Aggiusta la tua roba Comunità Store

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Handset Microphone Replacement

Introduzione

This will walk you through replacing the microphone on the handset.

Cosa ti serve

  1. Handset Microphone Replacement, Handset: passo 1, immagine 1 di 1

    • After removing the BP-T18 battery pack, you will see two 11mm Phillips #0 screws located at the bottom of the phone. Remove both screws with a screwdriver.

    • Product is made of brittle plastic.

    Traduci

  2. Handset Microphone Replacement: passo 2, immagine 1 di 2 Handset Microphone Replacement: passo 2, immagine 2 di 2

    • Locate an easy point of access for a spudger, and then slowly insert it into the gap and pry it open.

    • The opening should become bigger if you exert force at a 30 degrees angle.

    • Increase the degree of slant until the back cover is completely removed.

    Traduci

  4. Handset Microphone Replacement: passo 3, immagine 1 di 2 Handset Microphone Replacement: passo 3, immagine 2 di 2

    • After removing the back cover, you will see 3 screws: one 7mm Phillips #0 screw at the top and two 11mm Phillips #0 screws at the bottom.

    • Use a screwdriver to remove all 3 screws.

    Traduci

  5. Handset Microphone Replacement, Handset Microphone: passo 4, immagine 1 di 2 Handset Microphone Replacement, Handset Microphone: passo 4, immagine 2 di 2

    • After disassembling the handset, you will see the inner components of the handset.

    • Locate the rubber part towards the very bottom of the handset. This is the microphone with protective rubber cover.

    • Remove the protective rubber cover. This may require a spudger.

    • The microphone is exposed upon removal of the protective rubber cover. Avoid contact with water.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Autore

con 2 altri collaboratori

Han Shih

Membro da: 09/29/16

361 Reputazione

4 Guide realizzate

Distintivi: 10

+7 altri distintivi

Team

IUPUI, Team 3-3, Harley Fall 2016 Membro di IUPUI, Team 3-3, Harley Fall 2016

IUPUI-HARLEY-F16S3G3

4 Membri

17 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 4

Tutti i Tempi: 406