Aggiusta la tua roba Comunità Store

HTC Evo 3D Speaker Replacement

Introduzione

In this guide, we will show the steps necessary to replace the speaker in the HTC Evo 3D. This guide will help to restore audio from the rear speaker.

Cosa ti serve

  1. HTC Evo 3D Speaker Replacement, Speaker: passo 1, immagine 1 di 3 HTC Evo 3D Speaker Replacement, Speaker: passo 1, immagine 2 di 3 HTC Evo 3D Speaker Replacement, Speaker: passo 1, immagine 3 di 3

    • Remove the outer casing of the phone with your hands by prying and lifting at the latch.

    Modifica

  2. HTC Evo 3D Speaker Replacement: passo 2, immagine 1 di 2 HTC Evo 3D Speaker Replacement: passo 2, immagine 2 di 2

    • Remove the battery with your hands, lifting at the marked area.

    • Remove the SD card by pulling down on the bottom of the card.

    Modifica

  4. HTC Evo 3D Speaker Replacement: passo 3, immagine 1 di 1

    • Remove the four T5 screws using the cooresponding screwdriver.

    • Remove the two J000 screws using the cooresponding screwdriver.

    Modifica

  5. HTC Evo 3D Speaker Replacement: passo 4, immagine 1 di 2 HTC Evo 3D Speaker Replacement: passo 4, immagine 2 di 2

    • With the battery removed, the inner case of the phone can now be removed.

    • Using the plastic opening tool, pry the inner case off at the marked area. Continue prying around the entire perimeter of the phone.

    • This will remove the inner case, and allow access into the inner portion of the phone.

    • The marked part in the second photo is the speaker.

    Modifica

  6. HTC Evo 3D Speaker Replacement: passo 5, immagine 1 di 3 HTC Evo 3D Speaker Replacement: passo 5, immagine 2 di 3 HTC Evo 3D Speaker Replacement: passo 5, immagine 3 di 3

    • The speaker can be loosened from its glue with the spudger.

    • Pry from the bottom with constant pressure to loosen one end of the speaker.

    • When the speaker is sufficiently loosened, completely remove it by grabbing it with the precision tweezers.

    Modifica

  7. HTC Evo 3D Speaker Replacement: passo 6, immagine 1 di 1

    • With the old speaker removed, insert the new speaker in the same place.

    • When reinserting the new speaker, be sure that the golden contacts (As previously marked) are facing up.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order but with a new speaker.

Un'altra persona ha completato questa guida.

Autore

con 2 altri collaboratori

James Burke

Membro da: 08/26/15

245 Reputazione

2 Guide realizzate

Distintivi: 6

+3 altri distintivi

Team

USF Tampa, Team 14-20, Meier Fall 2015 Membro di USF Tampa, Team 14-20, Meier Fall 2015

USFT-MEIER-F15S14G20

5 Membri

10 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 3

Ultimi 7 Giorni: 8

Ultimi 30 Giorni: 11

Tutti i Tempi: 335