HTC Desire 610 Charging Port Replacement

Introduzione

Has your HTC Desire 610 stopped charging and you know it's not a battery or charging cord issue? Follow these steps to replace a faulty charging port in an HTC Desire 610. In this guide you will learn how to take off the back, unscrew the circuit cover, and safely take out the charging port to replace with a new one.

Cosa ti serve

Passo 1 Black Plastic Circuit Cover

HTC Desire 610 Charging Port Replacement, Black Plastic Circuit Cover: passo 1, immagine 1 di 3

HTC Desire 610 Charging Port Replacement, Black Plastic Circuit Cover: passo 1, immagine 2 di 3

HTC Desire 610 Charging Port Replacement, Black Plastic Circuit Cover: passo 1, immagine 3 di 3

Using a plastic opening tool, take off the back cover of the phone.

Modifica

Passo 2

Remove the four black 4mm torx screws using the Torx T5 bit.

Modifica

Passo 3

Remove the four silver 5mm torx head screws using the Torx T5 screwdriver.

Modifica

Passo 4

Remove the two 2.5mm phillips head screws using the Phillips 000 screwdriver.

Modifica

Passo 5

Remove the black plastic circuit cover using a plastic opening tool.

Modifica

Passo 6 Charging Port

HTC Desire 610 Charging Port Replacement, Charging Port: passo 6, immagine 1 di 1

Remove the 4mm black Torx screw using a Torx T5 screwdriver.

Modifica

Passo 7

Using a pair of tweezers, disconnect the antenna wire.

Modifica

Passo 8

HTC Desire 610 Charging Port Replacement: passo 8, immagine 3 di 3

Peel back the gray adhesive strip using the precision tweezers.

Modifica

Passo 9

Pull up on the white strip so it sits 90 degrees using a pair of precision tweezers.

Modifica

Passo 10

HTC Desire 610 Charging Port Replacement: passo 10, immagine 3 di 3

Pry up the circuit board and pull it out using a pair of precision tweezers.

Modifica

Passo 11

HTC Desire 610 Charging Port Replacement: passo 11, immagine 3 di 3

Remove the loud speaker using a pair of precision tweezers.
The loud speaker is attached with adhesive and may require more force than expected to remove.
The prongs on the speaker should be sticking up towards the top of the phone when you put the speaker on the new circuit board.