Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Make sure the computer is unplugged.
-
Make sure all auxiliary cords are disconnected from the desktop. If not, remove them using your hands.
-
Set the desktop down horizontally with the front side facing you.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Hold the desktop with two hands by grasping both sides of the desktop.
-
Press the buttons on both sides using your index fingers.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slide the top cover about an inch forward using your thumb to push it towards you.
-
Make sure that the bottom is still secured by both hands.
-
Lay the desktop back on the table and pull the case forward as far as it can go.
-
Lift the cover up and off.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using your hand, grip the Optical Drive and lift it up into a 45 degree angle.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disconnect the power supply cord and the SATA cord using your hands to pull them out.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using your left index finger, lift the upper green tab found on the left side of the green piece.
-
Using your opposite hand, use your fingers to push the back of the drive forward and slide it out away from the desktop.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Grasp the optical drive with your right or left hand and pull the drive out towards you.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using your right index finger, press the tab with the green sticker located underneath the power supply.
-
While pressing the tab, lift up the power supply the same way you lifted up the optical drive.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two cables on the motherboard by grasping the cables with your hand and pulling the cables up and out.
-
Repeat the same process to remove the internal card power cable.
-
This is the same process as preformed when you previously removed the power cables from the optical drive and the hard drive.
-
Some cables may have small clips securing them in place. If so, be sure to press these clips inward using your fingers before pulling them out.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Continue to rotate the power supply to a 90 degree angle pointing upward.
-
Gripping the power supply with your hand, lift the power supply up to remove from the desktop.
-
Annulla: non ho completato questa guida.
Altre 5 persone hanno completato questa guida.