Introduzione

Drop your computer again? Change that cracked HP Stream screen!

  1. Use a plastic spudger to remove two oblong screw covers on the bottom of the computer.
    • Use a plastic spudger to remove two oblong screw covers on the bottom of the computer.

    • Use a plastic spudger to remove four rubber feet.

    • To remove the feet you must break the glue seal holding them down.

    Aggiungi Commento

  2. Remove the eleven 5 millimeter housing screws from the bottom of the computer using a #00 Phillips head screwdriver.
    • Remove the eleven 5 millimeter housing screws from the bottom of the computer using a #00 Phillips head screwdriver.

    Aggiungi Commento

    • Turn the computer over and open it.

    • Use a plastic spudger to pry the keyboard bezel away from the base. Pry around the edge, being careful not to jam the spudger too far underneath the bezel (potentially damaging internal components).

    • The bezel is tightest near the hinge.

    • Once the bezel is free, do not lift it away from the base.

    Aggiungi Commento

    • Identify two ribbon connectors and the ZIF cable underneath the keyboard.

    • Use tweezers to disconnect both ribbon cables and the ZIF connector.

    Aggiungi Commento

    • Remove five 4 millimeter hinge-screws using a #00 Phillips head screwdriver.

    • There are three 4 millimeter hinge-screws on the right side.

    Aggiungi Commento

    • Use tweezers to disconnect the black power cable.

    • Remove the 3.5 millimeter screw from the WiFi chip using a #00 Phillips head screwdriver.

    • The upper and lower halves of the laptop should now be separated.

    Aggiungi Commento

    • Remove two 2 millimeter bezel screws using a #00 Phillips screwdriver.

    • Use a plastic spudger to pry the bezel away from the screen.

    • The bezel screws are covered by thin plastic.

    Aggiungi Commento

    • Remove four 3 millimeter screen screws using a #00 Phillips head screwdriver.

    • Lift the screen with steady pressure until the glue seal breaks and releases the lid.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 16

Tutti i Tempi: 106