Introduzione

Computer not holding a charge? Tired of looking for outlets everywhere you go? Change your HP Stream battery!

Use a plastic spudger to remove two oblong screw covers on the bottom of the computer.
  • Use a plastic spudger to remove two oblong screw covers on the bottom of the computer.

  • Use a plastic spudger to remove four rubber feet.

  • To remove the feet you must break the glue seal holding them down.

Aggiungi Commento

Remove the eleven 5 millimeter housing screws from the bottom of the computer using a #00 Phillips head screwdriver.
  • Remove the eleven 5 millimeter housing screws from the bottom of the computer using a #00 Phillips head screwdriver.

Aggiungi Commento

  • Turn the computer over and open it.

  • Use a plastic spudger to pry the keyboard bezel away from the base. Pry around the edge, being careful not to jam the spudger too far underneath the bezel (potentially damaging internal components).

  • The bezel is tightest near the hinge.

  • Once the bezel is free, do not lift it away from the base.

Aggiungi Commento

  • Identify two ribbon connectors and the ZIF cable underneath the keyboard.

  • Use tweezers to disconnect both ribbon cables and the ZIF connector.

Aggiungi Commento

  • Use a Phillips #00 screwdriver to remove six 5 millimeter screws from the battery.

Aggiungi Commento

  • Use a plastic spudger to remove the two power connectors.

  • Lift the battery out.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 10

Ultimi 30 Giorni: 36

Tutti i Tempi: 165