Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unplug the device from any energy sources.
-
Lift the top cover of the scanner.
-
Use a plastic opening tool to remove the plastic frame surrounding the glass.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully pull the frame away from the glass.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a T10 screwdriver to unscrew the two screws that fasten the frame to the printer hood.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Put your finger behind the panel with the power button.
-
Then, pull the piece outwards.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew the screw inside the power button panel space.
-
Then, unscrew the screw that is across the printer slider.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull the white circuit board outwards which is located under the small screen.
-
Unplug the small ribbon cable from the circuit board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unplug the small ribbon cable from the circuit board. Be careful when you unplug the ribbon cable not to use too much force. Using too much force may damage or rip the cable.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull the memory card reader's circuit board out.
-
Detach the white wiring connector from the back of the circuit board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Put your finger behind the small screen.
-
Then, pull it up.
-
Disconnect the ribbon cable from the small screen.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the scanning lid from the lower portion of the printer hood.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Leaving the ribbon connected, lift the sliding scanner off the track.
-
Pull the ribbon cable out of the slot on the scanner circuit board.
-
Insert the scanning piece into the rolling track.
-