1. Unplug the device from any energy sources.
    • Unplug the device from any energy sources.

    • Lift the top cover of the scanner.

    • Use a plastic opening tool to remove the plastic frame surrounding the glass.

    Aggiungi Commento

  2. Carefully pull the frame away from the glass.
    • Carefully pull the frame away from the glass.

    • If it doesn't remove easily, use the iFixit Opening Tool again to pry stuck sections.

    Aggiungi Commento

    • Use a T10 screwdriver to unscrew the two screws that fasten the frame to the printer hood.

    Aggiungi Commento

    • Put your finger behind the panel with the power button.

    • Then, pull the piece outwards.

    Aggiungi Commento

  3. Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    • Unscrew the screw inside the power button panel space.

      • Then, unscrew the screw that is across the printer slider.

    Aggiungi Commento

    • Pull the white circuit board outwards which is located under the small screen.

    • Unplug the small ribbon cable from the circuit board.

    • Be careful when you unplug the ribbon cable not to use too much force. Using too much force may damage or rip the cable.

    Aggiungi Commento

    • Unplug the small ribbon cable from the circuit board. Be careful when you unplug the ribbon cable not to use too much force. Using too much force may damage or rip the cable.

    Aggiungi Commento

    • Pull the memory card reader's circuit board out.

    • Detach the white wiring connector from the back of the circuit board.

    • You may need to use a finger nail or a plastic opening tool to detach the white wiring connector from the circuit board.

    Aggiungi Commento

    • Put your finger behind the small screen.

    • Then, pull it up.

    • Do not hesitate to use force to remove the TouchSmart panel.

    • Disconnect the ribbon cable from the small screen.

    Aggiungi Commento

    • Pull the printer hood upward.

    Aggiungi Commento

    • Lift the scanning lid from the lower portion of the printer hood.

    Remove torx screw on bottom of assembly in corner near touchsmart screen space.

    Jeff - Replica

    • Leaving the ribbon connected, lift the sliding scanner off the track.

    • Pull the ribbon cable out of the slot on the scanner circuit board.

    • Insert the scanning piece into the rolling track.

    Aggiungi Commento

Conclusione

To reassemble the sliding scan piece, follow these instructions in reverse order.

Renee Lamb

Membro da: 26/09/2012

226 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 2-11, Propen Fall 2012 Membro di Cal Poly, Team 2-11, Propen Fall 2012

CPSU-PROPEN-F12S2G11

4 Membri

6 Guide realizzate

Where can i buy the scaning piece? Im from Spain.

Bogdan Cosmin - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 8

Tutti i Tempi: 1,241