Salta al contenuto principale

HP Pavilion g4-1117dx Trackpad Replacement

Cosa ti serve

  1. HP Pavilion g4-1117dx Trackpad Replacement, Battery: passo 1, immagine 1 di 1
    • Slide pill shaped tab to the other side of the channel.

    • Remove battery while keeping the tab to the side.

  2. HP Pavilion g4-1117dx Trackpad Replacement, L-Shaped Back Panel: passo 3, immagine 1 di 1
    • Unscrew the two screws JIS #0 located on opposites sides of the panel.

    • Screws are attached to the panel and will not fully come out.

  3. HP Pavilion g4-1117dx Trackpad Replacement: passo 4, immagine 1 di 1
    • Carefully pry off the L-shaped panel.

  4. HP Pavilion g4-1117dx Trackpad Replacement, Hard Drive: passo 5, immagine 1 di 1
    • Pull out and unplug the tab on the right hand side.

  5. HP Pavilion g4-1117dx Trackpad Replacement, Larger Back Panel: passo 6, immagine 1 di 1
    • Unscrew all nine 6.0mm JIS #0 screws located on the border of the back panel.

  6. HP Pavilion g4-1117dx Trackpad Replacement: passo 7, immagine 1 di 1
    • Remove 3 screws located where the battery previously was.

  7. HP Pavilion g4-1117dx Trackpad Replacement: passo 8, immagine 1 di 2 HP Pavilion g4-1117dx Trackpad Replacement: passo 8, immagine 2 di 2
    • Remove 6 screws located under the spot where the smaller L-shaped panel was located.

  8. HP Pavilion g4-1117dx Trackpad Replacement: passo 9, immagine 1 di 1
    • Slowly pry off the keyboard from the back panel.

    • Between the back panel and the keyboard there are two ribbon wires.

    • Remove slowly to not break the back panel. If it does not come off easily, check to see if all screws are removed.

  9. HP Pavilion g4-1117dx Trackpad Replacement: passo 10, immagine 1 di 1
    • Unplug wires connecting back panel to keyboard.

  10. HP Pavilion g4-1117dx Trackpad Replacement, Trackpad: passo 11, immagine 1 di 1
    • Actual trackpad does not come out since it is a part of the whole keyboard.

    • Locate loosely attached blue strip at the bottom of the computer.

    • Locate the left ribbon strip attached to small black and white box.

    • Flip up the black tab while pulling out the ribbon.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Robert Hamilton

Membro da: 03/01/18

1.165 Reputazione

10 Guide realizzate

Team

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 481