Introduzione

The motherboard is the meat of your device. Almost everything on the inside such as the fan, mouse pad, and speakers, are all attached. Although the removal and replacement of this component is not difficult, it should be done cautiously.

  1. Slide pill shaped tab to the other side of the channel.
    • Slide pill shaped tab to the other side of the channel.

    • Remove battery while keeping the tab to the side.

    • Unscrew the two screws JIS #0 located on opposites sides of the panel.

    • Screws are attached to the panel and will not fully come out.

    • Carefully pry off the L-shaped panel.

    • Pull out and unplug the tab on the right hand side.

    • Unscrew all nine 6.0mm JIS #0 screws located on the border of the back panel.

    • Remove 3 screws located where the battery previously was.

    • Remove 6 screws located under the spot where the smaller L-shaped panel was located.

    • Slowly pry off the keyboard from the back panel.

    • Between the back panel and the keyboard there are two ribbon wires.

    • Remove slowly to not break the back panel. If it does not come off easily, check to see if all screws are removed.

    • Unplug wires connecting back panel to keyboard.

    • In lower left hand corner, pull on black tab to unplug the disc drive.

    • In upper left hand corner, unplug the large black electrical tape covered laptop plug.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Robert Hamilton

Membro da: 01/03/2018

1.051 Reputazione

10 Guide realizzate

Team

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 15

Tutti i Tempi: 158