Introduzione

This guide shows how to disassemble the HP Pavilion Sleekbook 14-b013cl in order to replace the cooling fan.

Parti

Nessuna parte richiesta.

  1. Flip the computer over and move the battery lock switch to the "unlocked" position (marked by an orange lock icon).
    • Flip the computer over and move the battery lock switch to the "unlocked" position (marked by an orange lock icon).

    Aggiungi Commento

  2. Press the switch on the right-hand side of the back of the device towards the center until the gray battery icon is no longer visible. This will eject the battery.
    • Press the switch on the right-hand side of the back of the device towards the center until the gray battery icon is no longer visible. This will eject the battery.

    Aggiungi Commento

    • Carefully pull the battery away from the device.

    Aggiungi Commento

    • Using a Phillips #0 screwdriver, unscrew all nine of the screws from the bottom of the computer.

    • There is a wire connecting the keyboard to the motherboard. Do not pull the keyboard away until you have disconnected the wire.

    Aggiungi Commento

    • Using a plastic opening tool, pry up along the edge of the keyboard.

    • There is a wire connecting the keyboard to the motherboard. Do not completely pull the keyboard off until the wire is disconnected.

    Aggiungi Commento

    • To disconnect the wire, pry up on the latch connecting it to the motherboard.

    Aggiungi Commento

    • Using a plastic or metal spudger, carefully pry apart the palm rest from the rest of the laptop.

    • Be careful when using the metal spudger, as you could damage the internal components if the spudger is inserted too far.

    • Do not completely pull the halves apart yet because there are still wires holding them together.

    Aggiungi Commento

    • Disconnect the touch pad wire by flipping the black lever with a plastic spudger.

    Aggiungi Commento

    • Unscrew the circuit board underneath the power button.

    • Remove this circuit board by pulling up and away on the plastic tab.

    Aggiungi Commento

    • Using a Phillips #0 screwdriver, remove all the screws and take the metal plate off the mother board.

    • Double sided tape holds the plate down as well as the screws. You will need to apply force to remove the plate.

    Aggiungi Commento

    • Remove the three screws holding the cooling fan in place using a Phillips #0 screwdriver.

    • Using a plastic opening tool, remove the power cable for the fan.

    • Remove the fan from the device.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 51