Introduzione

If the screen of your laptop is black when powered on, or cracked, it should be replaced. With the purchase of a new screen, follow these steps to replace it completely.

  1. Open your laptop. Beneath the screen, there is a large plastic piece that contains slots for a speaker, the power button, and numerous indicator lights.
    • Open your laptop. Beneath the screen, there is a large plastic piece that contains slots for a speaker, the power button, and numerous indicator lights.

    • To remove this, pry it open with a spudger tool gently. It should pop out of place.

    Aggiungi Commento

  2. Gently use a spudger tool or your fingers to disconnect the LCD cable from the screen.
    • Gently use a spudger tool or your fingers to disconnect the LCD cable from the screen.

    • This is one of three connectors that needs to be undone to disconnect the screen from the laptop.

    Aggiungi Commento

    • Remove the 1 cm screw with a Phillips #1 screwdriver to allow the screen and top of the laptop to be separated from the keyboard and bottom.

    • Lift the entire top away from the bottom, and set bottom half of the laptop aside.

    Aggiungi Commento

    • Remove the 6 rubber screw caps with a metal spudger.

    • After removing the 6 rubber screw caps, use a Phillips #1 screwdriver to unscrew the six 6mm screws.

    Aggiungi Commento

    • To separate the plastic cover, use a plastic opening tool to undo each plastic connecting clip between the two.

    • You can find the plastic connecting clips by sliding the plastic opening tool along the seam between the two plastic covers.

    • Remove the top plastic cover once all connections have been released.

    Aggiungi Commento

    • Disconnect the connectors using a plastic opening tool.

    • Once these two connectors are released, the screen should be electronically freed from the rest of the laptop.

    Aggiungi Commento

    • At each corner, there is a 1 centimeter silver screw connecting the screen frame to the laptop. Remove these using a Phillips #1 Screwdriver.

    Aggiungi Commento

    • There should be thin piece of copper 'tape' holding the LCD cable down. Remove this gently with tweezers.

    • Remove the screen from the device.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Emily Hatstat

Membro da: 19/03/2018

481 Reputazione

4 Guide realizzate

Team

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 28