Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the nylon spudger to remove the rubber pads near the hinge of the screen, then remove the screws under the pads.
-
Use the Phillips #0 to remove four 9mm screws.
-
Use the Phillips #0 to remove seven 6mm screws.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the nylon spudger to pry the back casing near the hinges for the screen.
-
Continue to pry along the edge of the back case until the back is ready to be removed.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the blue plastic opening tool to lift up on the white tab that is holding the cable in place on the motherboard.
-
Now carefully pull the cable out of place and remove the entire back casing.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the five 6mm screws that hold the battery in place using the Phillips #0.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the nylon spudger to pry away the blue/white wire that is positioned near your battery.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disconnect the battery cable from the motherboard by carefully pulling on the black wire at the point closest to the white tab.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the Phillips #0 to remove the two 3mm screws holding the fan in place.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the plastic opening tool to slowly loosen the connection cable.
-
Once the connector is loose enough, grab the cable and carefully pull it free from your device.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.