Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Grasp the scanner lid cover from the front of the device and lift lid all the way up until it stands on its own.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
With two hands, grasp the lid on both sides near the hinges and lift straight up to release the lid from each hinge.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Once you have removed the scanner lid, locate the finger notch on inside the top left half of the bezel (control) panel.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place your index finger in the notch and lift up to unsnap the panel.
-
Set panel cover aside.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a T9 torx screwdriver to remove the 0.9 cm screw.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
From the front of the printer, remove the button panel by pulling it towards you while slightly lifting it up.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disconnect the white ribbon cable by grasping it between your thumb and index finger.
-
Gently pull to release the ribbon from the green circuit board
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Next, use the flat end of a spudger to pry loose the flat ribbon computer cable by the plastic connection end and carefully separate it from the prongs on the button panel.
-
The entire button panel should now be completely disconnected from the printer.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lay the panel on a flat surface with the backside facing up.
-
Using a T9 torx screwdriver, remove all six 0.7 cm silver screws from the off-white plastic panel.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently lift the button panel off the plastic backing with rubber button mat.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert your new button panel. To reassemble your printer, follow these instructions in reverse order.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.