Salta al contenuto principale

Introduzione

This guide will teach you how to remove the Cover on your HP Officejet Pro 6835 or 6830 to reach the main components.

Parti

Nessuna parte specificata.

  1. Open the main lid as far as it will go.
    • Open the main lid as far as it will go.

    • Use a plastic opening tool to gently pry off the hinge on the right side by pushing it to the left and off the hook.

    • Open the lid further.

  2. Use a T9 torx screwdriver to remove a total of ten (10) 12mm screws from the main cover by turning the screwdriver counterclockwise. The two screws above the screen assembly are deep so you may need a long screwdriver. The two screws above the screen assembly are deep so you may need a long screwdriver.
    • Use a T9 torx screwdriver to remove a total of ten (10) 12mm screws from the main cover by turning the screwdriver counterclockwise.

    • The two screws above the screen assembly are deep so you may need a long screwdriver.

  3. Grab the main cover and lift it up slightly.
    • Grab the main cover and lift it up slightly.

    • Do not pull too hard—there is a cable connecting the cover to the printer.

  4. Grab the base of the white ribbon cable connecting the cover to the base of the printer and pull it out. Grab the base of the white ribbon cable connecting the cover to the base of the printer and pull it out.
    • Grab the base of the white ribbon cable connecting the cover to the base of the printer and pull it out.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Jake Park

Membro da: 24/01/2018

361 Reputazione

2 Guide realizzate

Team

Cal Poly, Team S2-G4, Livingston Winter 2018 Membro di Cal Poly, Team S2-G4, Livingston Winter 2018

CPSU-LIVINGSTON-W18S2G4

4 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 45