Introduzione

This guide will show you how to remove the LCD display.

  1. There is a hidden screw underneath the model sticker on the front panel.
    • There is a hidden screw underneath the model sticker on the front panel.

    • Peel the model sticker off the cover.

    • This will expose the T10 screw securing the panel.

    Aggiungi Commento

  2. Remove the single 12mm-T10 screw securing the front panel to the printer body.
    • Remove the single 12mm-T10 screw securing the front panel to the printer body.

    • Loosen the panel cover from the printer body.

    • There is a ribbon cable connected to the backside of the cover. Disconnect the cable before separating the panel completely.

    Aggiungi Commento

    • Gently remove the No-Fuss ribbon cable from the front panel.

    Aggiungi Commento

    • Remove the seven 8mm screws using the Torx T6 screwdriver.

    • Remove the motherboard from the front-panel housing.

    • The LCD display is on the opposite side.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Justin Engwall

Membro da: 23/01/2018

109 Reputazione

1 Guida realizzata

Team

Cal Poly, Team S18-G3, Livingston Winter 2018 Membro di Cal Poly, Team S18-G3, Livingston Winter 2018

CPSU-LIVINGSTON-W18S18G3

4 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 13

Tutti i Tempi: 143