Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Torx T5 screwdriver to remove the six 5.1 mm screws.
-
Use a JIS #1 screwdriver to remove the two 7.2mm screws.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a plastic opening tool to pry open the case. Go slowly around the edge. You will hear popping noises, such are due to popping open the small joints that keep the cover attached.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a JIS #1 screwdriver to remove the six 4.7 mm screws.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use tweezers to disconnect the battery from the motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully, pull back the locking clip of the connector using a plastic opening tool and disconnect cable.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a PH0 bit remove the 7 (2.8 mm) screws securing the touchpad to the device.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a plastic opening tool to pry up the touchpad.
-
Gently, pull out the touchpad from device.
-