Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Torx T5 screwdriver to remove the six 5.1 mm screws.
-
Use a JIS #1 screwdriver to remove the two 7.2mm screws.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a plastic opening tool to pry open the case. Go slowly around the edge. You will hear popping noises, such are due to popping open the small joints that keep the cover attached.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a JIS #1 screwdriver to remove the six 4.7 mm screws.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use tweezers to disconnect the battery from the motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a JIS J1 bit to remove the two 4.6 mm screws.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
The red square is around the ribbon cable.
-
Use the plastic opening tool to open the black security connector. then pull the ribbon cable to disconnect it from the motherboard.
-
Annulla: non ho completato questa guida.
Altre 3 persone hanno completato questa guida.