Introduzione

The motherboard is the main circuit board found in a laptop. It manages the communication between crucial electronic components that allow your computer to function. This guide will describe how to remove and replace the motherboard for HP Envy x360m6-aq005dx

  1. Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.
    • Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.

    Aggiungi Commento

  2. Use a Torx T5 head to remove the six 5.1 mm screws.
    • Use a Torx T5 head to remove the six 5.1 mm screws.

    • Use a JIS J1 to remove the two 7.2mm screws.

    Aggiungi Commento

    • Use Plastic opening tool to pry open the case. Go slowly around the edge. You will hear popping noises, such are due to popping open the small joints that keep the cover attached.

    Aggiungi Commento

    • Use a J1 to remove the six 4.7 mm screws.

    Aggiungi Commento

    • Battery might cause a small electric shock.

    • Use tweezers to disconnect the battery from the motherboard.

    Aggiungi Commento

  3. Spedizione gratuita per ordini superiori a $20
    Usa il codice BLUEANDBLACK al checkout
    Spedizione gratuita per ordini superiori a $20
    Usa il codice BLUEANDBLACK
    • Battery may cause a small electric shock

    • Use tweezers to disconnect the battery from the motherboard.

    Aggiungi Commento

    • Use the Plastic opening tool to disconnect the power cable from the fan

    Aggiungi Commento

    • Use your fingers to lightly pull the cable and disconnect it from the motherboard.

    Aggiungi Commento

    • Use a PH0 tool bit to loosen the four 6.5 mm screws.

      • Do not fully remove the screws, just enough to be unattached from the motherboard.

    • Use a JIS J1 bit to remove the two 7.7 mm screws.

    Aggiungi Commento

    • Use a J1 to remove the 4.7mm screws from the indicated positions

    • Use the J1 to remove 7.7mm screws from the indicated positions

    • Use the J1 to remove the 4.4mm screws from the indicated positions

    Aggiungi Commento

    • Using your hand, lift the screen hinge located in the top left corner. This will allow for easier removal of the motherboard.

    Aggiungi Commento

    • Flip the indicated colored latches with iFixit Opening Tools, then use iFixit Tweezers to release the cables attached to the motherboard.

    • Use the pointed iFixit tweezer to release the plug-in connectors.

    Aggiungi Commento

    • Using your hand, lift and pull the motherboard from inside your computer

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Matthew Martin

Membro da: 10/10/2017

501 Reputazione

5 Guide realizzate

Team

USF Tampa, Team S13-G17, Cagle Fall 2017 Membro di USF Tampa, Team S13-G17, Cagle Fall 2017

USFT-CAGLE-F17S13G17

4 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 16

Ultimi 7 Giorni: 74

Ultimi 30 Giorni: 348

Tutti i Tempi: 2,811