Salta al contenuto principale

Introduzione

The battery is the main power source for the laptop when not plugged in. The battery may contain a small amount of electric charge, so this guide will provide assistance in the battery's proper and safe removal.

  1. Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top. Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.
    • Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.

  2. Use a Torx T5 screwdriver to remove the six 5.1 mm screws. Use a JIS #1 screwdriver to remove the two 7.2mm screws. Use a JIS #1 screwdriver to remove the two 7.2mm screws.
    • Use a Torx T5 screwdriver to remove the six 5.1 mm screws.

    • Use a JIS #1 screwdriver to remove the two 7.2mm screws.

  3. Use a plastic opening tool to pry open the case. Go slowly around the edge.  You will hear popping noises, such are due to popping open the small joints that keep the cover attached.
    • Use a plastic opening tool to pry open the case. Go slowly around the edge. You will hear popping noises, such are due to popping open the small joints that keep the cover attached.

  4. Use a JIS #1 screwdriver to remove the six 4.7 mm screws. Use a JIS #1 screwdriver to remove the six 4.7 mm screws.
    • Use a JIS #1 screwdriver to remove the six 4.7 mm screws.

  5. Battery might cause a small electric shock.
    • Battery might cause a small electric shock.

    • Use tweezers to disconnect the battery from the motherboard.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

Matthew Martin

Membro da: 10/10/2017

615 Reputazione

5 Guide realizzate

Team

USF Tampa, Team S13-G17, Cagle Fall 2017 Membro di USF Tampa, Team S13-G17, Cagle Fall 2017

USFT-CAGLE-F17S13G17

4 Membri

7 Guide realizzate

Step 3 was the toughest!!! Case was difficult to separate.

Bo Hagen - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 17

Ultimi 7 Giorni: 61

Ultimi 30 Giorni: 498

Tutti i Tempi: 4,661