Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place computer with the screen down on a flat surface.
-
Push the two locking latches to the unlocked position.
-
Push the cover toward the top of the computer and lift up.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Press locking latch on the bottom of the base of the stand.
-
Pull the plastic cover off of the stand.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Torx T15 driver and stick it through the holes on the stand in order to remove the two 12mm screws on the back of the main unit.
-
Tilt stand and lift up to remove it.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Torx T15 driver to remove the single 10mm screw on the back panel.
-
Pull the back panel toward the bottom of the device to remove it.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Torx T15 driver to remove the four 10mm screws on the VESA mount cover.
-
Lift up on the VESA mount cover to remove it.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disconnect the power supply's black and yellow cable from the motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Torx T15 driver to remove the two 8mm screws on either side of the power supply.
-
Lift the power supply from the case to remove it.
-
Annulla: non ho completato questa guida.
Altre 6 persone hanno completato questa guida.