Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Introduzione

These steps must be followed before replacing any internal parts in the HP Deskjet 1000 J110a. Don't forget to keep track of the screws.

Parti

Nessuna parte specificata.

  1. Remove the two 13 mm screws located on the back of the printer using a screwdriver with the T10 torx bit (star-shaped). Remove the two 13 mm screws located on the back of the printer using a screwdriver with the T10 torx bit (star-shaped). Remove the two 13 mm screws located on the back of the printer using a screwdriver with the T10 torx bit (star-shaped).
    • Remove the two 13 mm screws located on the back of the printer using a screwdriver with the T10 torx bit (star-shaped).

  2. Kit cacciaviti Manta

    112 punte per ogni riparazione.

    Upgrade Your Toolbox

    Kit cacciaviti Manta

    Upgrade Your Toolbox
  3. In the front of the printer, open the tray where the paper comes out and remove the two 13 mm screws located under the top of the printer. In the front of the printer, open the tray where the paper comes out and remove the two 13 mm screws located under the top of the printer. In the front of the printer, open the tray where the paper comes out and remove the two 13 mm screws located under the top of the printer.
    • In the front of the printer, open the tray where the paper comes out and remove the two 13 mm screws located under the top of the printer.

  4. With the front of the printer facing you, lift and raise the left side of the panel (like opening a book in reverse) until it disconnects from the clip on the right side of the panel.
    • With the front of the printer facing you, lift and raise the left side of the panel (like opening a book in reverse) until it disconnects from the clip on the right side of the panel.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Colin Tourjee

Membro da: 29/01/2018

566 Reputazione

4 Guide realizzate

Team

USF Tampa, Team S5-G3, Passmore Spring 2018 Membro di USF Tampa, Team S5-G3, Passmore Spring 2018

USFT-PASSMORE-S18S5G3

4 Membri

6 Guide realizzate

Very intuitive, good instructions. Highly recommended.

Krzysztof Białkowski - Replica

Thank you very much for the instructions on removing the cover to the HP 1200 Deskjet. It allowed me to removed a part that fell into the printer and prevented the paper from advancing.

karenliller@comcast.net - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 10

Tutti i Tempi: 341