Introduzione

Easy and quick replacement of the Chromebook screen.

Parti

Nessuna parte richiesta.

We will be replacing the screen on this HP Chromebook. ***Unfortunately I did get a shot of the sweet crack on this screen.
  • We will be replacing the screen on this HP Chromebook. ***Unfortunately I did get a shot of the sweet crack on this screen.

  • We will start by removing this screws on the bottom left and right of the screen, just above the escape key and power button.

Aggiungi Commento

Next will start to remove the front "bezel" with a simple spudger. It is best to start from the bottom (now we here) of the screen.   *couldn't resist
  • Next will start to remove the front "bezel" with a simple spudger. It is best to start from the bottom (now we here) of the screen. *couldn't resist

  • The bottom will have adhesive/double sided tape that may or may not give you trouble. It is not enough to prevent you from removing the screen, just be aware as it is near the screen circuit board.

I found a really annoying super sticky black/silverfoil tape that was attached to the bezel and the actual panel, It was quite a bother to remove the bezel because of this. Please consider that this can happen when you try to wedge it off. (the reason it possibly isn't budging can be this tape)

Bo-John Woltman - Replica

  • Once removed, we can proceed to remove (4) screws that hold the screen to the laptop case.

    • Marked in blue are the locations for the screws. Screws are closest to screen and on a light silver bracket. Pull screen forward and lay down on keyboard.

Aggiungi Commento

  • The ribbon cable is connected at the bottom of the screen. Tape is placed over the connection and it is easily peeled and easy to reuse. I would not advise cutting the tape.

  • Connect your new screen and go backwards through the steps to install.

Aggiungi Commento

  • When re-installed and laptop is closed, check the back hinge area as it does not easily snap back in together. Pat yourself on the back if you can get it all together perfectly!

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Ricky

Membro da: 17/09/2013

722 Reputazione

3 Guide realizzate

Team

TechTucson WeFixThat Membro di TechTucson WeFixThat

Community

2 Membri

4 Guide realizzate

Great walkthrough but missed one of the screws in the first step. There's one on the right and left. Nothing a little superglue couldn't fix.

ronguyor - Replica

That ribbon connector sure is finicky, It's really hard to actually pop it back in without putting too much force to it and bending it up. (for me atleast)

Bo-John Woltman - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 17

Ultimi 30 Giorni: 63

Tutti i Tempi: 2,954