Salta al contenuto principale

Introduzione

Use this guide to remove the display assembly of the HP Chromebook 11 G3.

  1. Flip the laptop upside down so that the lid lies flat on the table. Remove the nine 6mm Phillips #00 screws that line the border.
    • Flip the laptop upside down so that the lid lies flat on the table.

    • Remove the nine 6mm Phillips #00 screws that line the border.

  2. Remove the two rubber feet closest to the hinge using tweezers. Remove the two 6mm Phillips #00 screws revealed under these rubber feet.
    • Remove the two rubber feet closest to the hinge using tweezers.

    • Remove the two 6mm Phillips #00 screws revealed under these rubber feet.

    • The rubber feet may tear while removal; preventing this can be difficult, but it won’t harm the laptop. If desired, replace these rubber feet during reassembly.

  3. Flip the laptop so it is in the upright position.
    • Flip the laptop so it is in the upright position.

    • Open the lid.

    • Unsnap the keyboard mount along the border of the laptop using a plastic opening tool.

    • This may require more force than expected. Hearing loud clicks as the plastic opening tool slides along the seam is normal.

  4. Tilt the keyboard mount up. Use a spudger to flip up the two ZIF connector retaining flaps for the ribbon cables that connect the keyboard mount to the motherboard. Gently remove both ribbon cables.
    • Tilt the keyboard mount up.

    • Use a spudger to flip up the two ZIF connector retaining flaps for the ribbon cables that connect the keyboard mount to the motherboard.

    • Gently remove both ribbon cables.

  5. Lift the keyboard mount out of the laptop.
    • Lift the keyboard mount out of the laptop.

  6. Gently tug on the black and white wires connected to the Wi-Fi module to disconnect them.
    • Gently tug on the black and white wires connected to the Wi-Fi module to disconnect them.

  7. Using a spudger, lift the ZIF retaining flap that secures the display’s ribbon cable to the motherboard. Gently pull the ribbon cable out of its socket.
    • Using a spudger, lift the ZIF retaining flap that secures the display’s ribbon cable to the motherboard.

    • Gently pull the ribbon cable out of its socket.

  8. Free the wire from the casing.
    • Free the wire from the casing.

  9. Remove the two 6mm Phillips #00 screws located near the upper left and right corners of the hinge mounts.
    • Remove the two 6mm Phillips #00 screws located near the upper left and right corners of the hinge mounts.

    • Hold the lid so that it is folded slightly inwards while removing the screws so that the lid doesn’t fall.

  10. Rotate the lid to a 90-degree angle with the table.
    • Rotate the lid to a 90-degree angle with the table.

    • Shimmy the lid out of the laptop.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Rahul Goyal

Membro da: 26/04/2017

1.337 Reputazione

10 Guide realizzate

Team

Cal Poly, Team S23-G3, Livingston Spring 2017 Membro di Cal Poly, Team S23-G3, Livingston Spring 2017

CPSU-LIVINGSTON-S17S23G3

4 Membri

12 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 10

Ultimi 30 Giorni: 27

Tutti i Tempi: 733