HP 15-r137wm TouchSmart Keyboard Replacement

Introduzione

You can use this guide to help you safely and effectively remove the keyboard from your HP 15-r137wm TouchSmart device. Be sure to follow all steps in order to ensure proper removal of components and connections. This guide is a prerequisite for all guides of this device following the removal of the keyboard, since it is required to remove the housing to access the components. The prerequisite guide of the front panel assembly is required for this guide.

Cosa ti serve

Passo 1 Front Panel Assembly

HP 15-r137wm TouchSmart Keyboard Replacement, Front Panel Assembly: passo 1, immagine 1 di 3

HP 15-r137wm TouchSmart Keyboard Replacement, Front Panel Assembly: passo 1, immagine 2 di 3

HP 15-r137wm TouchSmart Keyboard Replacement, Front Panel Assembly: passo 1, immagine 3 di 3

Make sure that the device is powered off and unplugged before removing components.
Remove all ten (10) 5.5 mm Phillips #0 screws.
Remove the two (2) plastic tabs located at the rear of the panel. Locate the two (2) 7.5mm Phillips #0 screws underneath the pads and remove.

Modifica

Passo 2

Attrezzo utilizzato in questo passaggio:

Anti-Static Wrist Strap

$7.95

Compra

Use a wide plastic opening tool to pry off the top casing.
Be cautious not to crack the casing near the keyboard as it is quite fragile.
Lift the cover off carefully as there are wires still attached to internal components.
After panel is removed, use an anti-static wrist strap to ensure the motherboard does not get any external shocks from static discharge.

Modifica

Passo 3

The connection for the track pad is still connected.
Move the keyboard slightly out of the way to locate the connection.
Disconnect the small wire protruding from the motherboard underneath the metal plate.