HP 15-ac121dx Screen Replacement

Introduzione

This is a straightforward guide on how to replace the HP 15-ac121dx Screen. The tools needed are the Phillips #000 Screwdriver and the iFixit Opening Tool. It is essential that this procedure is completed with care and attention to detail, since there are many components at risk of being damaged. The time needed to complete this procedure is approximately five minutes.

Cosa ti serve

Passo 1 Battery

HP 15-ac121dx Screen Replacement, Battery: passo 1, immagine 1 di 1

Remove all external devices from the computer.
Remove the charging cord from the computer.

Traduci

Passo 2

Turn off the computer by holding the power button.

Traduci

Passo 3

To remove the battery, slide the left slider on the back to the unlocked position.

Traduci

Passo 4

Push the right slider inwards.
Remove the battery out by pulling straight out and to the right.

Traduci

Passo 5 Screen

HP 15-ac121dx Screen Replacement, Screen: passo 5, immagine 1 di 1

Open the laptop so that the screen is facing you.

Traduci

Passo 6

With the screen facing you, use the plastic opening tool to remove the liner around the screen

Traduci

Passo 7

Using a Phillips #000 screwdriver, remove all four 2mm screws in each corner of the screen.

Traduci

Passo 8

Carefully remove the screen and place it face down on the keyboard.
Do not pull the screen away from the front panel assembly, as this would damage the cord connecting the screen to the front panel assembly.

Traduci

Passo 9

With the screen faced down on the keyboard, remove the grounding tape adhered to the back of the screen.
You should see a 36-pin plug underneath the grounding tape.
Carefully remove the 36-pin plug, not to damage the grounding tape or the plug.