Salta al contenuto principale

HP 14-ac151nr DC Power Jack Replacement

Cosa ti serve

  1. HP 14-ac151nr DC Power Jack Replacement, Backplate: passo 1, immagine 1 di 1
    • Remove battery by pushing the two buttons inward.

  2. HP 14-ac151nr DC Power Jack Replacement: passo 2, immagine 1 di 1
    • Remove the two rubber feet next to the battery.

  3. HP 14-ac151nr DC Power Jack Replacement: passo 3, immagine 1 di 1
    • Remove all 14 Phillips head #0 screws.

  4. HP 14-ac151nr DC Power Jack Replacement: passo 4, immagine 1 di 1
    • Use a plastic opener tool to pry off the black backplate.

  5. HP 14-ac151nr DC Power Jack Replacement, DC Power Jack: passo 5, immagine 1 di 2 HP 14-ac151nr DC Power Jack Replacement, DC Power Jack: passo 5, immagine 2 di 2
    • Remove the black tape near the power jack.

    • Remove the screws connecting monitor to the bottom of the computer.

  6. HP 14-ac151nr DC Power Jack Replacement: passo 6, immagine 1 di 1
    • Position the metal fittings attached to the monitor out of the way.

    • The monitor is still attached by wires — be careful not to pull on it too hard.

  7. HP 14-ac151nr DC Power Jack Replacement: passo 7, immagine 1 di 3 HP 14-ac151nr DC Power Jack Replacement: passo 7, immagine 2 di 3 HP 14-ac151nr DC Power Jack Replacement: passo 7, immagine 3 di 3
    • Disconnect the power jack from the motherboard.

    • Remove the power jack by lifting it up.

    • An opener tool may make this easier.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Team

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 5

Ultimi 30 Giorni: 15

Tutti i Tempi: 436