Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Peel off the paper backing from the sheet of grip tape.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Center the sheet of grip tape evenly over the top of the skateboard deck.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Starting from the very middle and moving outward, firmly press down on the grip tape while smoothing out any air bubbles that start to form.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a screwdriver to scrape along the edges of the skateboard. This will remove some of the grip around the edges making the trimming process easier on you and your equipment.
-
You can use the utility knife to cut a perpendicular line in the excess grip tape if it is resisting the screwdriver too much.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a utility knife to begin cutting around the edge of your skateboard to remove excess grip tape.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Once you have removed all of the excess grip tape, you can use the scraps to sand the edges of your cut to smooth out any small inconsistencies.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
If air bubbles persist, gently use a utility knife to poke a small hole in the grip tape at the center of the bubble and press out the air.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
After you have finished applying your grip tape, you can use a small screwdriver to poke holes where your truck hardware will be installed.
-
Annulla: non ho completato questa guida.
Altre 4 persone hanno completato questa guida.