Salta al contenuto principale

Google Pixel 3a XL Midframe Replacement

Solo Prerequisita
Questa guida è destinata a essere usata solo come prerequisito per altre guide. Da sola è incompleta.

Cosa ti serve

  1. Google Pixel 3a XL Midframe Replacement, Midframe: passo 1, immagine 1 di 1
    Attrezzo utilizzato in questo passaggio:
    Magnetic Project Mat
    $19.95
    Compra
    • Remove the following 4.3mm screws:

    • 14 silver T3 Torx screws

    • 2 black T3 Torx screws

    • Due to manufacturing tolerances, a T4 Torx driver may fit better into these T3 screws.

    • Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from.

  2. Google Pixel 3a XL Midframe Replacement: passo 2, immagine 1 di 3 Google Pixel 3a XL Midframe Replacement: passo 2, immagine 2 di 3 Google Pixel 3a XL Midframe Replacement: passo 2, immagine 3 di 3
    • The midframe is still held in place by plastic clips.

    • Insert an opening pick into the seam along the bottom of the phone.

    • Slide the pick along the seam to release the clips holding the midframe to the rest of the phone.

  3. Google Pixel 3a XL Midframe Replacement: passo 3, immagine 1 di 3 Google Pixel 3a XL Midframe Replacement: passo 3, immagine 2 di 3 Google Pixel 3a XL Midframe Replacement: passo 3, immagine 3 di 3
    • Slide the opening pick along the left and right edges of the phone to release the midframe clips there.

    • Once the clips along the bottom of the phone are separated, the flat edge of the opening pick should be enough to separate the rest of the clips.

    • Lift up the bottom edge of the midframe but don’t completely remove it yet. The midframe is still connected to the phone by a fragile cable.

  4. Google Pixel 3a XL Midframe Replacement: passo 4, immagine 1 di 2 Google Pixel 3a XL Midframe Replacement: passo 4, immagine 2 di 2
    • Use a spudger to pry up and detach the proximity sensor cable from the motherboard.

  5. Google Pixel 3a XL Midframe Replacement: passo 5, immagine 1 di 1
    • Remove the midframe from the phone.

  6. Google Pixel 3a XL Midframe Replacement: passo 6, immagine 1 di 2 Google Pixel 3a XL Midframe Replacement: passo 6, immagine 2 di 2
    • During reassembly, align the top edge of the midframe with the top of the phone, then use a spudger to carefully press the proximity sensor cable connector onto its socket.

    • This takes a bit of patience and finesse. Once you have the connector aligned, you can also use a finger to gently press the connector onto the socket.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Taylor Dixon

Membro da: 06/26/18

66.782 Reputazione

94 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 59