Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Start by removing the silver plastic face from the camera using a plastic opening tool. Insert the plastic opening tool into the middle of each edge and lift up the tabs that keep the camera face on.
-
The seven plastic tab locations are marked in red.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the three 8 mm Phillips #000 screws on each corner of the camera.
-
Remove the single 4 mm Phillips #000 screw on the bottom left corner of the camera.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
To remove the motherboard assembly from the camera casing, use the plastic opening tool on the lens side of the camera to pry the motherboard assembly out of the camera housing.
-
To avoid breaking the plastic on the lens side of the camera (see photo), pry along the edges near the corners.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the four 8 mm Phillips #000 screws securing the camera sensor assembly.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
To remove the sensor assembly, simply peel off the lens towards the attached ribbon cable.
-
The sensor has ribbon cables running to the motherboard via a black rectangular connector.
-
To remove the sensor, use the spudger to pry up each side, Then, lift the connector straight up from its socket.
-
With the old camera sensor assembly removed, you can now replace it with a new sensor.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the three 8 mm Phillips #000 screws securing the Hero port to the motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the copper-colored ribbon cables connecting the Hero Port to the motherboard.
-
To remove the connector, use tweezers or a spudger, pry up each side of the connector. Then, lift the connector straight up from it's socket.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
To remove the free port, simply slide it out from the left side of the camera. It should come out with slight coercion.
-
This piece can be replaced, fixed, or set aside for further tear-down of the GoPro.
-
Pictured left is the port when separated from the motherboard.
-
Annulla: non ho completato questa guida.
Altre 3 persone hanno completato questa guida.