Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

GoPro Hero3+ Silver Edition Image Sensor Replacement

Cosa ti serve

  1. GoPro Hero3+ Silver Edition Image Sensor Replacement, Battery: passo 1, immagine 1 di 2 GoPro Hero3+ Silver Edition Image Sensor Replacement, Battery: passo 1, immagine 2 di 2
    • Push the tab on the back of the device left to remove the plate covering the battery.

  2. GoPro Hero3+ Silver Edition Image Sensor Replacement: passo 2, immagine 1 di 1
    • Use the strip of tape on the battery to remove the battery from the housing.

  3. GoPro Hero3+ Silver Edition Image Sensor Replacement, Front Panel: passo 3, immagine 1 di 1
    • Insert a plastic opening tool in between the front face plate and the black housing.

    • Make sure you insert the plastic opening tool next to the microSD card slot. There is a small gap that will help separate the face plate.

  4. GoPro Hero3+ Silver Edition Image Sensor Replacement: passo 4, immagine 1 di 1
    • Continue to use the plastic opening tool and separate the front face plate from the rest of the device.

    • There is adhesive that helps attach the front face plate. Some extra prying may be required to separate the face plate, but do not use excessive force.

  5. GoPro Hero3+ Silver Edition Image Sensor Replacement, Image Sensor: passo 5, immagine 1 di 3 GoPro Hero3+ Silver Edition Image Sensor Replacement, Image Sensor: passo 5, immagine 2 di 3 GoPro Hero3+ Silver Edition Image Sensor Replacement, Image Sensor: passo 5, immagine 3 di 3
    • Locate the four 8.1mm PH00 screws on the corners of the GoPro and unscrew them using the phillips screwdriver.

    • Gently remove the motherboard by using a plastic opening tool to pry it out of the housing.

    • Be careful not to damage the ribbon cable connected to the GoPro housing and motherboard.

  6. GoPro Hero3+ Silver Edition Image Sensor Replacement: passo 6, immagine 1 di 2 GoPro Hero3+ Silver Edition Image Sensor Replacement: passo 6, immagine 2 di 2
    • Remove the ribbon cable by carefully flipping the black clip up with the plastic opening tool and pulling the cable out.

  7. GoPro Hero3+ Silver Edition Image Sensor Replacement: passo 7, immagine 1 di 1
    • Remove the four 4mm PH00 screws attaching the image sensor to the motherboard with your screwdriver.

  8. GoPro Hero3+ Silver Edition Image Sensor Replacement: passo 8, immagine 1 di 2 GoPro Hero3+ Silver Edition Image Sensor Replacement: passo 8, immagine 2 di 2
    • Pry off the last ribbon cable with a plastic opening tool.

    • Remove the image sensor from the motherboard.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 4 persone hanno completato questa guida.

Team

Cal Poly, Team 5-8, Maness Fall 2015 Membro di Cal Poly, Team 5-8, Maness Fall 2015

CPSU-MANESS-F15S5G8

4 Membri

12 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 3

Tutti i Tempi: 744