Introduzione
A rhinoceros ate the rear case of your GoPro? No questions here; you can replace it with a new one.
Cosa ti serve
-
-
Place your thumb on the indentation in the back case on the side of the GoPro.
-
Gently press down with your thumb and lift the back cover away from the case to remove it.
-
-
-
Slide a plastic opening tool between the battery and the rear case.
-
Gently pry the battery up and out of the rear case.
-
-
-
Remove the four Phillips #00 screws securing the rear case to the rest of the device:
-
Two 5.5 mm coarse thread screws.
-
Two 4.4 mm fine thread screws.
-
-
-
Attrezzo utilizzato in questo passaggio:Tweezers$4.99
-
Using a plastic opening tool or your fingernail, flip up the locking tab on the SD board ribbon cable ZIF connector on the motherboard assembly.
-
Use a pair of tweezers to remove the SD board ribbon cable from its connector on the motherboard.
-
-
-
Remove the two 5.8 mm Phillips #00 screws securing the SD board cover to the rear case.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.
Un commento
FYI the item that you're disassembling is not the SD card slot, it's the plug for HD Hero accessories such as the Wifi backpack and LCD screen. The SD card is inserted from the side not the back.