Introduzione

This guide will explain how to replace the power supply cable of the General Electric Bagel Switch 4-Slice toaster.

  1. Unplug the toaster from the electrical outlet.
    • Unplug the toaster from the electrical outlet.

    Aggiungi Commento

  2. Remove the two levers and four dials by pulling them out directly towards you.
    • Remove the two levers and four dials by pulling them out directly towards you.

    • Removing these components may require some force, but they will release.

    Aggiungi Commento

    • Look for the plastic clips on the back side of the toaster.

    • Disconnect the small plastic clips on the back of the toaster. Use Philips head Screwdriver to do this step.

    • Now, carefully remove the toaster casing.

    Aggiungi Commento

    • Flip the toaster over so that the bottom plate is facing up.

    Aggiungi Commento

    • Remove the four screws from the bottom of the toaster.

    Aggiungi Commento

    • Carefully separate the bottom plate from the metal components inside the toaster.

    Aggiungi Commento

    • Using wire cutters, cut the power supply cable close to the base of the toaster, leave about 2 inches of wire.

    Aggiungi Commento

    • Pull the power supply cord through the bottom plate of the toaster.

    Aggiungi Commento

    • Insert the end of the new power supply cable through the hole in the bottom plate.

    Aggiungi Commento

    • Strip about an inch of the wire insulation (casing) off the ends of both the new power supply cable, and the old power supply cable that is still attached to the toaster.

    Aggiungi Commento

    • Splice the stripped ends of wire together using a wire cap.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 308