Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Repairing Gateway no.mg1 Hdd locked

Cosa ti serve

  1. Repairing Gateway no.mg1 Hdd locked, Battery: passo 1, immagine 1 di 1
    • Move the latch to the right of the battery to unlock.

  2. Repairing Gateway no.mg1 Hdd locked: passo 2, immagine 1 di 1
    • Slide the latch on the left directly below the battery to unlock and pull out the battery as shown.

    • The latch must be held in position to remove the battery.

  3. Repairing Gateway no.mg1 Hdd locked, Hdd locked: passo 3, immagine 1 di 1
    • Before you begin, it's recommended that you back up all your computer's information on the original hard drive. Also, verify the laptop is off and all cables are disconnected.

    • Turn the laptop over so the bottom is facing up.

  4. Repairing Gateway no.mg1 Hdd locked: passo 4, immagine 1 di 2 Repairing Gateway no.mg1 Hdd locked: passo 4, immagine 2 di 2
    • Loosen the three Philips cover screws that secure the hard drive.

    • These screws cannot be fully removed from the hard drive cover.

    • Use the spudger to lift and to remove the hard drive cover.

  5. Repairing Gateway no.mg1 Hdd locked: passo 5, immagine 1 di 2 Repairing Gateway no.mg1 Hdd locked: passo 5, immagine 2 di 2
    • Slide the original hard drive to the left and lift it to remove.

    • Insert the new hard drive.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 5 persone hanno completato questa guida.

Team

Cal Poly, Team 24-20, Regan Spring 2010 Membro di Cal Poly, Team 24-20, Regan Spring 2010

CPSU-REGAN-S10S24G20

4 Membri

14 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 5

Ultimi 30 Giorni: 12

Tutti i Tempi: 13,889