Salta al contenuto principale

Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.

Cosa ti serve

  1. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 1, immagine 1 di 1
    • Place the laptop so the back cover is facing up.

  2. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 2, immagine 1 di 1
    • Remove the 8 screws from the back cover using the Phillips #00 screwdriver.

  3. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 3, immagine 1 di 1
    • Lift off the cover.

  4. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 4, immagine 1 di 1
    • Unplug the fan’s power cable, which is a group of black wires attached to a white plastic head on the motherboard.

    • Pull the plastic part of the cable, not the wires, so that the plug does not break.

  5. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 5, immagine 1 di 1
    • Remove the two screws located on opposite sides of the fan with a Phillips #00 screw driver.

  6. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 6, immagine 1 di 1
    • The fan is permanently attached to the silver heat sink next to the RAM.

    • To completely remove the parts, loosen the heat sink’s four screws with a Phillips #00 screw driver.

    • Take out the screws in the numerical order shown on the heat sink.

  7. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 7, immagine 1 di 1
    • Pull the fan and heat sink toward you at a 20 degree angle upward.

Linea Traguardo

Altre 2 persone hanno completato questa guida.

Toni Pipes

Membro da: 10/05/10

333 Reputazione

7 Guide realizzate

Team

Cal Poly, Team 21-31, Regan Fall 2010 Membro di Cal Poly, Team 21-31, Regan Fall 2010

CPSU-REGAN-F10S21G31

4 Membri

14 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 10

Ultimi 30 Giorni: 15

Tutti i Tempi: 4,914