Introduzione

You will remove the back cover, remove screws from the fan and heat sink, and take out the fan from the laptop.

Parti

Nessuna parte richiesta.

Place the laptop so the back cover is facing up.
  • Place the laptop so the back cover is facing up.

Aggiungi Commento

Remove the 8 screws from the back cover using the Phillips #00 screwdriver.
  • Remove the 8 screws from the back cover using the Phillips #00 screwdriver.

Aggiungi Commento

  • Lift off the cover.

Aggiungi Commento

  • Unplug the fan’s power cable, which is a group of black wires attached to a white plastic head on the motherboard.

  • Pull the plastic part of the cable, not the wires, so that the plug does not break.

Aggiungi Commento

  • Remove the two screws located on opposite sides of the fan with a Phillips #00 screw driver.

Aggiungi Commento

  • The fan is permanently attached to the silver heat sink next to the RAM.

  • To completely remove the parts, loosen the heat sink’s four screws with a Phillips #00 screw driver.

  • Take out the screws in the numerical order shown on the heat sink.

Aggiungi Commento

  • Pull the fan and heat sink toward you at a 20 degree angle upward.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Toni Pipes

Membro da: 05/10/2010

297 Reputazione

7 Guide realizzate

Team

Cal Poly, Team 21-31, Regan Fall 2010 Membro di Cal Poly, Team 21-31, Regan Fall 2010

CPSU-REGAN-F10S21G31

4 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 7

Tutti i Tempi: 4,603