Aggiusta la tua roba Comunità Store

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Gateway 600YG2 Top Case Replacement

Introduzione

removal of top case

Cosa ti serve

  1. Gateway 600YG2 Top Case Replacement, Battery: passo 1, immagine 1 di 1

    • Flip the laptop over.

    • Slide the battery release tab to the right with your index finger to open the battery cover.

    Traduci

  2. Gateway 600YG2 Top Case Replacement: passo 2, immagine 1 di 1

    • Remove the battery cover using the tab on the right side.

    • Take the battery out with your index finger.

    Traduci

  3. Gateway 600YG2 Top Case Replacement, Power Button Panel: passo 3, immagine 1 di 1

    • Insert the spudger between the "sysrq" and "ins" keys.

    • Gently pry free the power button panel above the keyboard, beginning from the right and moving to the left.

    Traduci

  4. Gateway 600YG2 Top Case Replacement, Keyboard: passo 4, immagine 1 di 1

    • Remove the 5 screws holding the keyboard in place.

    Traduci

  5. Gateway 600YG2 Top Case Replacement: passo 5, immagine 1 di 2 Gateway 600YG2 Top Case Replacement: passo 5, immagine 2 di 2

    • Potential for device damage: When lifting the keyboard out, do not lift the keyboard up. Only fold back along the space bar edge.

    • Potential for device damage: Do not pull the black cable by the ribbon section. Only pull it from the connector itself.

    • Follow the black ribbon cable to the connector and gently pull straight up.

    Traduci

  6. Gateway 600YG2 Top Case Replacement, LCD: passo 6, immagine 1 di 1

    • Remove the five screws with a Phillips #0 screwdriver.

    • The LCD hinge covers are held in place by four screws. One screw is for grounding the LCD.

    • Lift the hinge covers along the outer edges with the spudger until they are released.

    Traduci

  8. Gateway 600YG2 Top Case Replacement: passo 7, immagine 1 di 1

    • Gently unplug the LCD from the system board.

    Traduci

  9. Gateway 600YG2 Top Case Replacement: passo 8, immagine 1 di 1

    • Using the Phillips #0 screwdriver, remove six screws that hold the LCD to the hinge.

    Traduci

  10. Gateway 600YG2 Top Case Replacement: passo 9, immagine 1 di 1

    • Check if any cables are still connected before pulling out the LCD.

    • Remove the cable by gently pulling it out while holding down the LCD.

    Traduci

  11. Gateway 600YG2 Top Case Replacement, CD/DVD or Floppy drives: passo 10, immagine 1 di 1

    • Slide the release and push the button to eject the drive.

    • Remove the drive.

    • When reinserting the drives, be sure to put them in the original slot to avoid interface conflicts.

    Traduci

  12. Gateway 600YG2 Top Case Replacement, Top Case: passo 11, immagine 1 di 1

    • Remove 13 screws from bottom of computer

    Traduci

  13. Gateway 600YG2 Top Case Replacement: passo 12, immagine 1 di 1

    • Remove screws

    Traduci

  14. Gateway 600YG2 Top Case Replacement: passo 13, immagine 1 di 1

    • remove 4 screws from back of case

    Traduci

  15. Gateway 600YG2 Top Case Replacement: passo 14, immagine 1 di 1

    • WARNING Failure to do this step will damage mouse pad ribbon.

    • Lift plug holding mouse ribbon about 1/16 inch or until it stops

    • remove ribbon

    Traduci

  16. Gateway 600YG2 Top Case Replacement: passo 15, immagine 1 di 1

    • Insert spudger between upper and lower case at drive bay closest to battery.

    • Carefully and slowly go arount entire case unseating all plastic clips holding upper to lower.

    Traduci

  17. Gateway 600YG2 Top Case Replacement: passo 16, immagine 1 di 1

    • Lift upper case free about 1/4 inch

    • At rear of case is one last connecting wire. Unplug and remove upper case

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Autore

con 8 altri collaboratori

Elizabeth Mazer

Membro da: 10/14/10

78 Reputazione

10 Guide realizzate

Distintivi: 11

+8 altri distintivi

Team

Cal Poly, Team 20-10, Maness Fall 2010 Membro di Cal Poly, Team 20-10, Maness Fall 2010

CPSU-MANESS-F10S20G10

3 Membri

22 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 4

Tutti i Tempi: 1,867