Salta al contenuto principale
  1. Use a plastic spudger tool to remove the plastic frame. Insert the tool into the groove in the center of the top of the outer frame and lever it gently until it pops out. Insert the tool into the groove in the center of the top of the outer frame and lever it gently until it pops out.
    • Use a plastic spudger tool to remove the plastic frame.

    • Insert the tool into the groove in the center of the top of the outer frame and lever it gently until it pops out.

  2. Use a phillips head screw driver to remove all four screws in the corners around the screen. Set the screws aside for later. Set the screws aside for later.
    • Use a phillips head screw driver to remove all four screws in the corners around the screen.

    • Set the screws aside for later.

  3. Gently pull from both ends to separate the front panel from the back. Do not force the pieces apart wider than the length of the connecting wires or you will damage the wiring.
    • Gently pull from both ends to separate the front panel from the back.

    • Do not force the pieces apart wider than the length of the connecting wires or you will damage the wiring.

  4. Batterie per PC portatili

    Una soluzione semplice per un grande aumento di potenza.

    Acquista ora

    Batterie per PC portatili

    Una soluzione semplice per un grande aumento di potenza.

    Acquista ora
  5. Locate the white wire clip.  Gently unplug it using either your fingers or tweezers. Locate the white wire clip.  Gently unplug it using either your fingers or tweezers. Locate the white wire clip.  Gently unplug it using either your fingers or tweezers.
    • Locate the white wire clip. Gently unplug it using either your fingers or tweezers.

  6. Carefully expose both halves of the device.
    • Carefully expose both halves of the device.

    • Be sure to not pull the two halves apart too hard to avoid damaging the black wire.

  7. Locate the battery bracket and two screws. Remove both screws. Remove both screws.
    • Locate the battery bracket and two screws.

    • Remove both screws.

  8. Carefully peel the metal bracket away from battery. Pull the battery away from back cover. You may need to use a soldering iron and tongs to remove battery from the speakers.
    • Carefully peel the metal bracket away from battery.

    • Pull the battery away from back cover.

    • You may need to use a soldering iron and tongs to remove battery from the speakers.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Adrian Leon

Membro da: 07/10/2010

169 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 22-1, Maness Fall 2010 Membro di Cal Poly, Team 22-1, Maness Fall 2010

CPSU-MANESS-F10S22G1

3 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 8

Tutti i Tempi: 4,150