Introduzione

This device can be identified utilizing the criterion on the device page. When replacing the screen, be sure to set aside the following tools: T5 Torx screwdriver and plastic opening tool.

Parti

Nessuna parte richiesta.

  1. Carefully remove model/serial number sticker.
    • Carefully remove model/serial number sticker.

    Aggiungi Commento

  2. Remove two 4mm T5 Torx screws located under the sticker.
    • Remove two 4mm T5 Torx screws located under the sticker.

    Aggiungi Commento

    • Once the screws are removed, use the plastic opening tool to carefully separate the body from the screen encasing.

    Aggiungi Commento

    • Once the body of the nüvi is separated, carefully flip the tabs on the motherboard that secure the ribbon cable to the motherboard and disconnect.

    Aggiungi Commento

    • Use a plastic opening tool to loosen the three clips located on the top of the screen encasing to a position that loosens the hold on the screen.

    Aggiungi Commento

    • Use a plastic opening tool to loosen the two clips on the short sides of the Nuvi screen encasing to a position that allows the removal of the screen.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Hunter Johnson

Membro da: 27/03/2018

315 Reputazione

2 Guide realizzate

Team

IUPUI, Team S3-G5, Harley Spring 2018 Membro di IUPUI, Team S3-G5, Harley Spring 2018

IUPUI-HARLEY-S18S3G5

3 Membri

2 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 3

Tutti i Tempi: 109