Introduzione

This device can be identified utilizing the criterion on the device page. When replacing the motherboard, be sure to set aside the following tools: T5 Torx screwdriver, PH #0 screwdriver, and plastic opening tool.

  1. Carefully remove model/serial number sticker.
    • Carefully remove model/serial number sticker.

    Aggiungi Commento

  2. Remove two 4mm T5 Torx screws located under the sticker.
    • Remove two 4mm T5 Torx screws located under the sticker.

    Aggiungi Commento

    • Once screws are removed, use the plastic opening tool to carefully separate the body from the screen encasing.

    Aggiungi Commento

    • Once the body of the nüvi is separated, carefully flip the tabs on the motherboard that secure the ribbon cable to the motherboard and disconnect.

    Aggiungi Commento

    • Once the body of the nüvi is separated and the ribbon cable is disconnected, remove the three 1.6mm Phillips #0 screws.

    Aggiungi Commento

    • Carefully disconnect the two cables connecting the battery to the motherboard and remove motherboard.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Hunter Johnson

Membro da: 27/03/2018

315 Reputazione

2 Guide realizzate

Team

IUPUI, Team S3-G5, Harley Spring 2018 Membro di IUPUI, Team S3-G5, Harley Spring 2018

IUPUI-HARLEY-S18S3G5

3 Membri

2 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 89