Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the barcode sticker at the bottom of the device.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove two 8.4 mm T5 screws from the bottom of the device.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a plastic opening tool, carefully pry open the device.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew the four 6.70 mm screws holding the motherboard in place using a philips #0 screw driver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift up the motherboard.
-
Carefully disconnect the battery and motherboard. Slowly wiggling the connection makes it easier to disconnect the battery from the motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the plastic opening tool as a wedge, pry the battery from the case. This can be fairly tough as the battery is glued to the case. Don't be afraid to use force and some good leverage.
-
Annulla: non ho completato questa guida.
Altre 15 persone hanno completato questa guida.
9 Commenti
Thanks for the guide. Used it to open up a Nuvi 265 because the battery had been left to discharge below the protection circuit's limit. Connected the battery leads (Green = ground, Red = voltage, Black = temperature) to a 5v USB charger for ~20 seconds to revive the protection circuit, and the unit is now charging again. If you're going to do this, know the risks. Thermal runaways in lithium batteries can be extremely volatile.