Introduzione

Replacing the speaker in a Garmin Nuvi 200.

Peel off the sticker from the bottom of the device to reveal two screws.
  • Peel off the sticker from the bottom of the device to reveal two screws.

Aggiungi Commento

Remove two T5 Torx screws.
  • Remove two T5 Torx screws.

Aggiungi Commento

  • Insert a plastic opening tool in the gap between the front and rear casing.

  • Carefully work the tool around the gap, separating the two halves of the case.

    • Keep the power switch in place while removing the rear case.

Aggiungi Commento

  • Unscrew the two screws on opposite sides of the speaker using the #00 Phillips screwdriver.

Aggiungi Commento

  • Pull the cable out to detach the speaker from the logic board.

Aggiungi Commento

  • Wedge the iPod opener into the space between the speaker and the case.

  • Apply pressure to pry the speaker away from the case.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

Anjelica

Membro da: 11/04/2010

504 Reputazione

6 Guide realizzate

Team

Cal Poly, Team 25-90, Amido Spring 2010 Membro di Cal Poly, Team 25-90, Amido Spring 2010

CPSU-AMIDO-S10S25G90

4 Membri

9 Guide realizzate

just a note i had a problem with the speaker in my nuvi 200 an upon opening up found speaker plug had come loose i guess from being dropped a few times pushed plug in an works fine please check all connections before replacing your speaker saved me $$ thanks for a great site everyone...

randaleholland - Replica

Where can you buy replacement speakers for the Garmin units?

Brat Fry - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 10

Tutti i Tempi: 6,426