Introduzione

Be very careful when handling connector wires, as they are incredibly easily broken. This guide is unique only in removing the circuit board from the screen.

Parti

Nessuna parte richiesta.

Remove the six T5 Torx 6.32mm screws securing the back cover to the watch.
  • Remove the six T5 Torx 6.32mm screws securing the back cover to the watch.

Aggiungi Commento

Remove the back cover carefully.
  • Remove the back cover carefully.

  • Even after the screws have been removed, the back cover can still be quite difficult to take off. Moderate to extensive prying may be required. Be gentle, but firm.

Aggiungi Commento

  • Remove the orange gasket.

Aggiungi Commento

  • Remove the screen and motherboard assembly from the case.

Aggiungi Commento

  • Use a metal spudger to remove the golden retaining clip from the screen. There will be some adhesive to break.

Aggiungi Commento

  • Remove the screen from the golden metal clip.

Aggiungi Commento

  • Unhinge the black retaining hinge by prying it open with the metal spudger; Your fingernails will work as well.

Aggiungi Commento

  • Remove the connector from the motherboard by pulling it free at the base.

  • Make sure to pull from the base of the connector wire, as it is very easy to rip the wire from the screen.

Aggiungi Commento

  • Remove the screen from the motherboard.

  • Notice our tape retaining the connector to the screen. This is so easy to rip!

Aggiungi Commento

  • Remove the motherboard from the screen.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Evan Miller

Membro da: 21/03/2018

205 Reputazione

2 Guide realizzate

Team

IUPUI, Team S4-G1, Baechle Spring 2018 Membro di IUPUI, Team S4-G1, Baechle Spring 2018

IUPUI-BAECHLE-S18S4G1

3 Membri

3 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 18

Tutti i Tempi: 64