1. Remove the batteries from the camera to prevent danger of electric shock.
    • Remove the batteries from the camera to prevent danger of electric shock.

    Aggiungi Commento

  2. Locate all five screws on the camera. Then proceed to remove all the screws.
    • Locate all five screws on the camera. Then proceed to remove all the screws.

    Aggiungi Commento

    • Beware, if your screwdriver does not fit properly, you may damage the screws' heads.

    • If your screwdriver does not fit, or you do not have the proper one, you can use a hot glue gun to fix the screwdriver to the head of the screw. Wait for it to harden slightly, and then try to remove the screws.

    Aggiungi Commento

    • Remove outer case. Pull the back away from the main body of the camera.

    Aggiungi Commento

    • Locate the LCD screen and anchoring screw.

    • Remove screw.

    Aggiungi Commento

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Carefully pull the LCD screen away from the board it is connected to.

    Aggiungi Commento

    • Push both blue switches away from the holding device to unleach lcd ribbon.

    • Be careful when removing ribbon. If you damage it, you will need to replace it as well.

    Aggiungi Commento

    • Carefully detach the ribbon from where it was connected by the blue pins.

    Aggiungi Commento

    • Now that everything has been disconnected from the board, remove LCD screen.

    Aggiungi Commento

    • Remove the two screws holding the circuit board down.

    Aggiungi Commento

    • Remove black sticky tape from circuit board and camera case.

    Aggiungi Commento

    • Gently pull the circuit board away from the front side of the camera.

    • Be careful when removing assembly as to not break any solder leads or damage lens assembly.

    Aggiungi Commento

    • Remove the logic board by pulling straight away from assembly.

    Aggiungi Commento

    • Locate the flash unit of the camera. It includes the camera's flash and a capacitor.

    Aggiungi Commento

    • Unsolder the flash unit at it's three points.

    • Be careful not to damage the circuit board or surrounding parts with the solder iron.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Cody

Membro da: 18/04/2010

47 Reputazione

4 Guide realizzate

Team

Cal Poly, Team 7-11, Maness Spring 2010 Membro di Cal Poly, Team 7-11, Maness Spring 2010

CPSU-MANESS-S10S7G11

3 Membri

4 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 3,629