Salta al contenuto principale

Fugoo Tough XL Case Replacement

Cosa ti serve

  1. Fugoo Tough XL Case Replacement, Case: passo 1, immagine 1 di 1
    • Remove the four 3 mm screws located in each corner using a 3 mm Hex screwdriver.

  2. Fugoo Tough XL Case Replacement: passo 2, immagine 1 di 2 Fugoo Tough XL Case Replacement: passo 2, immagine 2 di 2
    • Gently pull up and off the outer casing.

    • Do not feel afraid to use a bit of force if necessary.

  3. Fugoo Tough XL Case Replacement: passo 3, immagine 1 di 2 Fugoo Tough XL Case Replacement: passo 3, immagine 2 di 2
    • Remove the internal device from the outer casing.

    • Remove the four 12 mm screws on each corner using a T10 Torx screwdriver.

    • Remove the eight 6 mm screws on the top and bottom using a T10 Torx screwdriver.

  4. Fugoo Tough XL Case Replacement: passo 4, immagine 1 di 3 Fugoo Tough XL Case Replacement: passo 4, immagine 2 di 3 Fugoo Tough XL Case Replacement: passo 4, immagine 3 di 3
    • Use your hands to gently remove the side plates.

    • Use an opening tool to pry off the back plate with the Fugoo trademark.

  5. Fugoo Tough XL Case Replacement: passo 5, immagine 1 di 1
    • Slowly pull the front casing from the back casing. Avoid putting any tension on the connected cables.

    • Separate the two slowly and consistently to avoid damaging the speaker cables.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Abdul

Membro da: 02/17/17

527 Reputazione

4 Guide realizzate

Team

USF Tampa, Team S19-G1, Hoffman Spring 2017 Membro di USF Tampa, Team S19-G1, Hoffman Spring 2017

USFT-HOFFMAN-S17S19G1

4 Membri

5 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 5

Tutti i Tempi: 934