Introduzione

Due to excessive use or damage, the efficiency of the solar panel will slowly decrease over time. Once that time has come, this guide will aid you on replacing a damaged or inefficient solar panel using the existing power cord.

Open the case by pulling the back tab  toward you in a downward motion.
  • Open the case by pulling the back tab toward you in a downward motion.

Aggiungi Commento

Unscrew the two Phillips #2 5mm screws that hold the power cord in place.
  • Unscrew the two Phillips #2 5mm screws that hold the power cord in place.

Aggiungi Commento

  • Use the flat-end of the spudger to pry off the clamp which holds the cord down.

Aggiungi Commento

  • Use the soldering iron to melt down the solder on each terminal by holding the tip of the iron against the solder until it becomes liquefied.

Aggiungi Commento

  • Gently pull the leads free from the terminals. If they do not easily separate from the terminals, repeat Step 4.

  • Now any solar panel of appropriate Voltage rating can be used to charge the device by soldering the wire leads to the new panel. Try to find a panel with similar specifications to avoid overloading the battery.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Vincent C

Membro da: 23/09/2014

131 Reputazione

1 Guida realizzata

Team

USF Tampa, Team 12-5, Blackwell Fall 2014 Membro di USF Tampa, Team 12-5, Blackwell Fall 2014

USFT-BLACKWELL-F14S12G5

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 198