Introduzione

Speakers are the key parts within an amplifier that produce the final sound of your guitar strokes. There are two main reasons for replacing a speaker: blowing out the previous ones or upgrading for better sound and overall tone. Regardless of the reason this guide will take you through the removal and installation steps of this guide.

  1. Make sure to unplug the power cord!
    • Make sure to unplug the power cord!

    • Take off the back panel by unscrewing the four Phillips head screws on the back of the amplifier.

    • Keep the screws in a safe place and mark what part they are for.

    Aggiungi Commento

  2. Make sure to unplug the power cord and have the amplifier turned off.
    • Make sure to unplug the power cord and have the amplifier turned off.

    • Unplug the audio cable running from the port labeled "INT. Speakers" to the audio speakers.

    • You should know have clean access to the speakers.

    Aggiungi Commento

  3. Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    • Locate the wire leads on the speaker that you are replacing. Notice that there are three wires and four connections.

    • Note where each wire goes. (White is positive and black is negative.

    • Remove the wires from the speaker leads.

    Aggiungi Commento

    • Remove all the screws on the perimeter of the speaker. Use locking pliers to remove the nuts. There are eight bolts holding the speaker in place.

    • Pull the old speaker off of the board and insert the new speaker the same way you removed the old one.

    • When tightening the nuts back down on the bolts, be sure to tighten them by alternating, working in diagonals. (i.e. once you tighten one down go diagonal from it and work on the next one.

    • Repeat with the other speaker if necessary.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 4 persone hanno completato questa guida.

Documenti Allegati

Ryan Brown

Membro da: 20/02/2014

210 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 9-27, Maness Winter 2014 Membro di Cal Poly, Team 9-27, Maness Winter 2014

CPSU-MANESS-W14S9G27

5 Membri

6 Guide realizzate

Thanks for the tutorial.

csharpconsultant - Replica

Am I missing a step here? You have the chassis in the way to access to speakers. Do u remove the chassis or do you remove the tolex with the speakers attached to it? Thanks

Albert - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 9

Ultimi 30 Giorni: 41

Tutti i Tempi: 3,819