Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Take off the back panel by unscrewing the four Phillips head screws on the back of the amplifier. You will find the six preamp tubes are the smaller ones on the right. (The picture only shows five of the six.)
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the metal casing by gently pressing up against the case and twisting to the right.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the cloth, remove one tube by firmly grasping and gently pulling downwards.
-
Pulling directly downwards prevents damage to the hookup prongs at the bottom of the tube.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Check the tube for any cracks in the glass. Also check to make sure the filaments are not burnt out.
-
If the tube is still functioning or to insert the replacement or, proceed to step five.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Take the new replacement tube and insert it into the appropriate slot, making sure that the prongs at the end line up with the correct holes.
-
You should hear a click when the tube is secured in place.
-
Repeat these steps with the other three tubes if necessary.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.