Introduzione

This guide will show the user how to replace the retention pin on a 2016 Toyota Tacoma for a Tonneau Trifold Bed cover.

Strumenti

Parti

Nessuna parte richiesta.

  1. Use the Allen wrench and apply constant pressure counterclockwise to loosen the pins
    • Use the Allen wrench and apply constant pressure counterclockwise to loosen the pins

    • The pins are tight and may require some force.

  2. Repeat step one until both pins have been loosened. The pin should be loose enough to remove by hand.
    • Repeat step one until both pins have been loosened. The pin should be loose enough to remove by hand.

    • Once loosened, grab both pins and pull them out.

    • Line up the holes on the replacement part, then insert the pins.

    • Hand tighten the bolts.

    • Tighten down one side then proceed to the next step.

    • Do not over tighten because you can strip the screw.

    • Tighten down the final side.

    • Do not over tighten because you can brake the allan wrench and strip the screw.

Conclusione

To reassemble your device, follow these instructions in order.

Christopher King

Membro da: 16/01/2018

133 Reputazione

1 Guida realizzata

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 1

Tutti i Tempi: 63