Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
With the indentation as leverage, use your fingernail to pry the bottom portion of the back cover from the phone.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slide the back cover down and remove it from the phone.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a fingernail in this indentation to push the battery toward the top of the phone
-
Pull the battery out away from the phone.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use your finger to slide the SIM card straight down out of its tray.
-
Remove the SIM card from your Fairphone.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
If you have a microSD card, use your finger to slide it straight out of its slot.
-
Remove the microSD card from your phone.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the five 3.9 mm Phillips #000 screws securing the midframe to the display assembly.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use an opening pick to carefully pry the midframe away from the display assembly.
-
Start just below the volume rocker and work your way down toward the bottom of the phone, freeing the plastic clips along the side.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully round the corner, separating the midframe from the display assembly.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Run the opening pick and pry along the top seam.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Separate any remaining clips and remove the midframe from the phone.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the flat end of a spudger to disconnect the antenna cable connector.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the tip of a spudger to flip open the tab on the daughterboard data cable ZIF connector.
-
Use tweezers to pull the daughterboard data cable away from its socket.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the following screws securing the Wi-Fi daughterboard to the display assembly:
-
Two 2.5 mm Phillips #000 screws
-
One 1.6 mm Phillips #000 screw
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use tweezers to gently pry the board up and remove it from the phone.
-
Annulla: non ho completato questa guida.
Altre 9 persone hanno completato questa guida.